How To Use Lucas Transmission Fix?

We may earn commission from links on this page at no extra cost to you. We only recommend products we back!

How to Use Lucas Transmission Fix

However, the manufacturer recommends that you can input Lucas Transmission Fix to existing transmission fluid but you should check the fluid levels first to prevent overfill. If you find the level high then remove the proper amount of ATF. For example, if you add a full bottle of Lucas then you should remove 24 ounces of transmission fluid. You can lose some bolts on the transmission pan to make this happened.

Then you have to heat your vehicle’s engine and transmission to reach the operating temperatures. Besides, you should leave the car idle at least 20-30 minutes before start adding the additive. The reason is Lucas is thick and if it is not dissolved ideally it may sink to the bottom of the pan.

Let’s open your car’s hood and find the transmission dipstick. If you don’t find it, you may get help online or the vehicle’s user manual to discover the exact location. After finding the location, remove the dipstick, and then add a funnel in its place.

Then slowly add the exact amount of Lucas Transmission Fix through the funnel till all of it is finished. However, most of the vehicles need one bottle but some larger vehicles may need two. Besides 12 ounces Lucas Transmission fluid is enough for most compact and sub-compact vehicles. Finally re-insert the transmission dipstick and then close the hood.

To ensure that the entire additive has appropriately dissolved, let’s drive the car and shift through all the gear. You will get the answer immediately.

Read More: Lucas Tranmission Fix Review

How Does Lucas Transmission Fix Work?

Transmission slipping, rough shifting, and hesitations

A clogged valve body, worn clutch plates, or poor transmission bands often cause slipping, and rough shifting. To prevent these hesitations Lucas will be your appropriate option. Its additives and blend of friction modifiers greatly help to restore transmission bands. At the same time, it helps improve friction between clutch plates and prevents any varnish buildup in the valve body. Besides Lucas Transmission Fix helps to smooth out shifting and allow clutch plates and transmission bands to engage gears suitably.

Seal leaks

Seals have to be smooth and leak proof. However, they can eventually harden and break down. As a result, fluid can escape. To prevent this situation lucid additive will be the right decision as it helps to soften them up again as well as increase them to cover a larger area.

Non-solvent formula

While choosing any transmission fluid additive it is important to check that it doesn’t contain any solvents. Solvents reduce ATF’s lubrication properties and cause seals to exhaust faster. As a result, it increases the change of both leaks and overheating. As Lucas doesn’t include solvents, so it will be the safest option to use with the transmission.

Adding to existing transmission fluid

The most impressive feature of Lucas Transmission Fix is it is very thick right out of the bottle. So you are allowed to easily add this Lucas Transmission Fix into your existing transmission fluid.

Who Is This For?

As we mentioned earlier if you are suffering from rough shifting, transmission slipping, or seal leaks, then Lucas Transmission Fix will be the appropriate option for you. Even if you are looking for an inexpensive option before resort to a repair shop, you should try this Lucas Transmission Fix. It will be a better alternative than go for repair and will save you hundreds of dollars.

However, this transmission xix will work great as long as the problems aren’t too heavy. It is recommended to find out the issue before it goes out of hand. If you are looking for a better solution for hard shifts and slipping then Lucas Transmission Fix is the reliable option. As it comes with a very viscous blend of friction modifiers, the transmission fix will help to improve fluid pressure. Ultimately you will have smooth sifting. It also helps clutch plates engage more economically. Overall this Lucas Transmission Fix is a money saving option.

On the other hand, you can use this Lucas Transmission Fix in the meantime of slipping, stalling, or leaks until you can bring it in for repairs. Sometimes, a bit of extra time saves huge and that’s where Lucas Transmission Fix is effective. It means you can use this transmission fix as an initial solution to prevent damage to internal parts of the engine. However, some people suggest using Lucas Transmission Fix after a fluid change but if you looking for some time for long-term transmission care and preventative maintenance then you shouldn’t buy this one. 

Final words

Hopefully, now you know how to use Lucas transmission fix. We covered this article’s researched and detailed information so you can have the most out of it. It is important to keep in mind that a transmission additive like Lucas is not the all in one solution. It will reduce several problems and allow the transmission to run longer. If you are looking for a permanent solution you have to rebuild or replace the transmission. Thanks for reading!